At a glance
This rf amplifier is a good fit for makers, students and electronics hobbyists.
Ideal For
- Everyday use
Buying Tip
Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.
Overview
The 3-30mhz DIY 12W SWR Meter Kit SWR Power Meter for Shortwave Radio Station Debugging QRP SWR Meter Module is listed in our rf amplifier range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.
Before you order
Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.
Specifications:
Name: SWR meter
Material: PCB
Frequency: 3-30mhz
Maximum measurement power: nominal 10W, actual measurement 12W
Minimum measurement power: greater than 0.5W
Connector: BNC
Maximum short-term power at full SWR meter resolution: 7W
Current drawn from transceiver to power circuits: 1.2mA
Features:
1. It is small and light, powered by RF tap power, no battery required, easy to carry, and very suitable for amateur radio enthusiasts to use in the field.
2. It can be used to measure RF signals, and it uses 6 LEDs to indicate the power strength and SWR range of the signal.
3. It is used to test the signal-to-noise ratio of shortwave radio signals with a frequency range of 3-30MHz. The input power does not exceed 12W, and the LED light corresponding to the minimum display value requires 0.5W power, which is suitable for various shortwave radio equipment.
4. The device is commonly used in radio communication systems such as radio broadcasting, television broadcasting, and radio communication.
5. It helps operators determine the strength of the signal and adjust the settings of the radio equipment to improve the quality and reliability of the signal.
6. There are no components that need to be adjusted in the entire circuit, and it can work normally as long as the connection is correct. IN is the RF input and OUT is the RF output. IN is connected to the RF ANT and OUT is connected to the antenna.
7. It can be used in the shortwave range without any calibration and adjustment, which is very simple and convenient for DIY enthusiasts.
Package Include:
1 x DIY Standing Wave Meter Kit (set)






Explore more
Cheaper Alternatives

Donut Broadband Antenna 10kHz-180MHz SMA Male Omnidirectional Shortwave Mediumwave Antenna for Quansheng UV-K5/K6 Walkie Talkies SDR Receiver Malahit-DSP2 Pocket Radio

ADS-B 1090MHZ Antenna Gain 2.0dBi Frequency Range 1060-1120 MHz
DC-4.0GHz Radio Frequency Fixed Attenuator RF Amplifier Module
Upgrade Options
High Power RF Amplifier 433MHz 25W Wide Frequency Range 390-470MHz Intelligent Temperature Control High Gain 30dB SMA-K Connector
UNI-730A Automatic Paddle Key Keyer CW Morse Code for HAM Radio with Silver Plating and 3.5mm Jack

HF20A Short Wave Full-Length Single-Line Traveling Wave Antenna 1000W Max Power 0-800KM Range SWR<2.0 High Radiation Efficiency Portable








