
1 / 5 · Click to enlarge
At a glance
This electronics is a good fit for makers, students and electronics hobbyists.
Ideal For
- Arduino, ESP32 and Raspberry Pi projects
- School and college lab work
- Prototypes and test rigs
Buying Tip
Read the full specifications and the package contents list below to make sure it does what you need.
Overview
The 3.5inch TFT 480*320 50FPS Touch Screen Display ABS Case Kit for Raspberry Pi 4B is listed in our electronics range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.
Before you order
Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.
Introduction:
If Raspberry Pi is equipped with GPIO display drivers,the HDMIport will have no signal output
Install LCD driver
sudo rm -rf LCD-show git clone https://github.com/goodtft/LCD-show.git chmod -R 755 LCD-show cd LCD-show/ sudo ./LCD35-show
- If Raspberry Pi is equipped with GPIO display drivers such as MPI2411, MPI2418, MPI2801, MPI3201, MPI3501, etc., the HDMIport will have no signal output
- If you need to switch back to the HDMIdisplay mode, execute:
cd LCD-show/ sudo ./LCDhdmi
Download LCD Driver Manually
- Driver download
Download:File:LCD-show.tar.gz
Touch screen calibration
- This LCD can be calibrated using a program called xinput_calibrator
- Install it with the commands:
cd LCD-show/ sudo dpkg -i -B xinput-calibrator_0.7.5-1_armhf.deb
- Click the Men button on the task bar, choose Preference -> Calibrate Touchscreen.
- Finish the touch calibration following the prompts. Maybe rebooting is required to make calibration active.
- You can create a 99-calibration.conf file to save the touch parameters (not necessary if file exists).
/ect/X11/xorg.conf.d/99-calibration.conf
- Save the touch parameters
1 x ABS box case
1 x touch screen
1 x touch screen pen
















