Skip to main content

Worldwide Shipping · Secure Payments

At a glance

This test & measuring module is a good fit for makers, students and electronics hobbyists.

Ideal For

  • Arduino, ESP32 and Raspberry Pi projects
  • School and college lab work
  • Prototypes and test rigs

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Overview

The ATU-200 1.9-54MHz 150W Automatic Antenna Tuner Update Version of ATU-100 ATU100 Firmware Programmed Soldered Full Set is listed in our test & measuring module range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.


Features:
- It can be equipped with long wire, GP, inverted V, positive V, dipole antennas, etc.
- It can be applied to any shortwave machine within 200w (as long as it can output 5-15w during tuning)
- With continuous radio frequency, you can tune. Such as am, cw, fm), without control line, short wave automatic tuning
- The relay adopts SMI, OMRON 12V, 10A, 16A high-power relay.
- Adopt PIC16F1938 MCU and 7 LC combinations were used.
- Adopt 7 hollow inductors design, and adopt 6 kV, high voltage ceramic chip capacitor.
- Adopt SMI-12V, 10A relay, MAX, 200W, it is recommended to use no more than 150W for a long time.
- This tool set not includes the shell, you can make a shell for it as you like.
- The tuning impedance ran-ge is 5Ω~1.1KΩ.

Specifications:
Tuning impedance range: 5ohm~1.2Kohm
Power supply voltage range: 11-15 V DC
Maximum current consumption: 600 mA
Maximum working power: 200 watts
Power required to start tuning: 10 watts
The smallest possible measurement power: 0.1 watts
Power measurement accuracy: 10%
Maximum installation inductance: 10μH
Minimum installation step of inductance: 0.05μH
Maximum installed capacity: 869 pF
Minimum capacitance installation steps: 5pF
Typical consumption 200-500 mA
Colour:blue
Size: about 290 x 185 x 60mm

Note:
- The case as this picture shows, it is not a special shell for the machine. It needs to be drilled and assembled by the customer.
- Since the relays purchased in each batch are products of different manufacturers, the models will be different, but the technical indexes adopted are similar, which all meet the requirements of product use. Therefore, different batches of products adopt different relays. Each product sent out is powered on and tested OK. Please feel free to use it.
- In non-power-on state, some internal fasteners of relays will make sounds when tilting or moving, which is a normal phenomenon.
- Power-on, no noise.
- During the tuning process, there will be an action sound, which is normal.

Package includes:
1 x ATU-200 turner board
1 x Set of accessories
1 x Case


Product Safety Information