
1 / 8 · Click to enlarge
At a glance
Made by LILYGO, this electronics is a good fit for makers, students and electronics hobbyists. Main specs: model comparison SX1280; support frequency 2.4 Ghz; high efficiency pa +12dBm.
Key Highlights
- Wireless connection
- Model comparison: SX1280
- Support frequency: 2.4 Ghz
- High efficiency PA: +12dBm
Ideal For
- Arduino, ESP32 and Raspberry Pi projects
- School and college lab work
- Prototypes and test rigs
Buying Tip
Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.
Specifications
| Model comparison | SX1280 |
|---|---|
| Support frequency | 2.4 Ghz |
| High efficiency PA | +12dBm |
| Low power RX | 9.9mA |
| Model number | SX1280 |
Overview
The LILYGO® T3S3 ESP32-S3 LoRa SX1262/SX1276 SX1280 2.4G Development Board WiFi Bluetooth Wireless Module 0.96 Inch OLED Display Type-C, made by LILYGO, is listed in our electronics range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.
Specifications explained
- Model comparison: SX1280
- Support frequency: 2.4 Ghz (confirm your cable or board uses the same connector)
- High efficiency PA: +12dBm
- Low power RX: 9.9mA
Before you order
Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.
Introduction:
T3S3 is a new version of the LoRa series (formerly LoRa32 series ), which carries the SX1280 LoRa module, supports the LoRa 2.4G frequency band, which supports global use, and is also equipped with the ESP32 main control chip, which supports TF cards.
It is recommended to control the output power of the SX1280 chip between 2-5 dBm when using the SX1280 PA module, to ensure that the entire module outputs a power of 20 dBm. If the output power of the SX1280 chip is higher than 5 dBm, it will exceed the maximum allowable input for the FEM chip and cause damage. However, if the output power is lower than 2 dBm, the module's output power will still be within 20 dBm. Therefore, the output power setting of the SX1280 chip must be carefully controlled and not exceed 2-5 dBm to avoid damaging the FEM chip. Setting the output power to 3 dBm will ensure an output power of 20 dBm.
Specification:
MCU: ESP32S3 Flash: 4MB PSRAM: 2MB Communication protocol: Wi-Fi + Bluetooth 5.0 + BLE Bluetooth Low Energy Onboard functions: reset + BOOT button, support TF card, built-in/external antenna switchable Power supply mode: support USB power supply / 3.7V lithium battery power supply, battery power switch Screen: 0.96 inches SSD1306 Driver I2C OLED Resolution: 128x64 I2C Interface: SDA-IO18 SCL-IO17
Package includes:
1 X T3S3
2 X 2.54mm Male PIN (1*13P)
1 X Battery Cable
1 X LoRa Antenna (optional)








Quick specs
- Model comparison
- SX1280
- Support frequency
- 2.4 Ghz
- High efficiency PA
- +12dBm
- Low power RX
- 9.9mA














