At a glance
Made by Raspberry Pi, this electronics is a good fit for makers, students and electronics hobbyists.
Ideal For
- Arduino, ESP32 and Raspberry Pi projects
- School and college lab work
- Prototypes and test rigs
Buying Tip
Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.
Overview
The Raspberry Pi Duplex MMDVM Digital Hotspot Board UHF/VHF Dual Timing Support Dual Antennas Ready to Use, made by Raspberry Pi, is listed in our electronics range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.
Before you order
Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.
Duplex variant of MMDVM_HS_Hat: This PCB uses the MMDVM_HS . It has two ADF7021 onboard and allows for duplex operation with two time slots on DMR. The default bit error rate is less than 5%, and the default 0ffset is 0. If the bit error rate is more than 5%, as long as the signal can be received, it can be corrected by 0ffset. Features:
- Fully tested - Supports DMR, P-25,D-Star and System Fusion - Onboard LEDs to show status (Tx,Rx,PTT,Mode) - Up to 10mW RF power - SMA antenna connector,Antenna included - Mounts cleanly on all current Raspberry Pi's including the Pi Zero - The firmware is pre-loaded and is easily upgraded via software. - UHF 430-450 MHz,433mhz and 900MHz VHF 144 220 Opera FREQ: The upper part is TX,the lower is RX antenna. UHF+VHF SMA,antenna Modem select: STM32_HS_GPIO Set TX frequency,RX frequency TX,RX frequency had better 10M or more apart. SLOT1,SLOT2 support. Package includes: 1 x MMDVM duplex HotSPOT Module 2 x Antenna(UHF) 2 x SMA socket 1 x Aluminum alloy shell





















