Skip to main content

Worldwide Shipping · Secure Payments

At a glance

This 3d printer limit switch is a good fit for makers, students and electronics hobbyists. Main specs: item type Collision Sensor; length (mm) 96; width (mm) 80. Check that your power source supplies 3.3 to 5.5 before connecting it.

Key Highlights

  • Item Type: Collision Sensor
  • Length (mm): 96
  • Width (mm): 80

Ideal For

  • Upgrading or repairing a 3D printer
  • Spare parts for long prints
  • Testing new materials

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

Item TypeCollision Sensor
Length (mm)96
Width (mm)80
Model No. / NameHS S31P
Weight (g)15
Operating Voltage (V)3.3 to 5.5
Model SeriesHS S31P
Shipping Weight0.01 kg
Shipping Dimensions9 × 9 × 2 cm

Overview

The HS-S31P, Collision Sensor is listed in our 3d printer limit switch range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Item Type: Collision Sensor
  • Length (mm): 96 (measure your mounting space before ordering)
  • Width (mm): 80 (measure your mounting space before ordering)
  • Model No. / Name: HS S31P
  • Weight (g): 15 (important for drones, RC models and anything you carry)
  • Operating Voltage (V): 3.3 to 5.5 (match this to your power supply; too high a voltage can damage the part)
  • Model Series: HS S31P
  • Shipping Weight: 0.01 kg (important for drones, RC models and anything you carry)

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

The HS-S31P, Collision Sensor switch module is essentially a micro snap-action switch, also known as a micro switch, which is an electronic switch activated by very small physical pressure. It can be directly connected to a single-chip microcomputer. It integrates the load resistor with the LED indicator. This makes it easier to test it. When physical pressure triggers the switch to close, the LED indicator on the board will light up. The principle of the collision switch is relatively simple, as shown in the following schematic diagram. When it is triggered to close by external force, the switch is closed and the module outputs a low level; when the external force is removed, the switch is opened and the module outputs a high level.


Features:

  1. Works with 3.3V to 5.5V power
  2. 3-pin connector (GND, VCC, Signal)
  3. Has a built-in LED indicator
  4. Uses a mechanical switch
  5. Outputs LOW when pressed, HIGH when released
  6. Two mounting holes (3mm, 10mm apart)
  7. Easy to connect and use
  8. Compatible with Arduino, ESP32, and more

Package Includes:

1 x HS-S31P, Collision Sensor

Quick specs

Item Type
Collision Sensor
Length (mm)
96
Width (mm)
80
Model No. / Name
HS S31P
Weight (g)
15
Operating Voltage (V)
3.3 to 5.5
See all specifications