Skip to main content

Worldwide Shipping · Secure Payments

At a glance

Made by Orange, this rotary encoder is a good fit for everyday home and hobby use. Main specs: model no. / name Magnetic Encoder; supply voltage 4.5 ~ 24; supply current 14. Check that your power source supplies 4.5 ~ 24 before connecting it.

Key Highlights

  • Model No. / Name: Magnetic Encoder
  • Supply Voltage: 4.5 ~ 24
  • Supply Current: 14

Ideal For

  • Everyday use

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

Model No. / NameMagnetic Encoder
Supply Voltage4.5 ~ 24
Supply Current14
Output Current (mA)< 0.1
Leakage Current10µA
Opt. Relative Humidity(RH)20% ~ 85% RH
Operating Temperature (°C)-40 ~ +85
Diameter (mm)41.85
Weight (g)25
Shaft ID(mm)10.5
Shipping Weight0.03 kg
Shipping Dimensions10 × 8 × 4 cm

Overview

The OE-775 Hall Effect Two Channel Magnetic Encoder, made by Orange, is listed in our rotary encoder range and suits everyday home and hobby use. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Model No. / Name: Magnetic Encoder
  • Supply Voltage: 4.5 ~ 24 (match this to your power supply; too high a voltage can damage the part)
  • Supply Current: 14 (your supply must deliver at least this much current)
  • Output Current (mA): < 0.1 (your supply must deliver at least this much current)
  • Leakage Current: 10µA (your supply must deliver at least this much current)
  • Opt. Relative Humidity(RH): 20% ~ 85% RH
  • Operating Temperature (°C): -40 ~ +85
  • Diameter (mm): 41.85

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

A two-channel Hall effect encoder is used to sense the rotation of a magnetic disk on a rear protrusion of the motor shaft. The quadrature encoder provides a resolution of 7 counts per revolution of the motor shaft when counting both edges of both channels. The encoder has four i/o pins as shown.

OE-775 Hall Effect Two Channel Magnetic Encoder's Hall sensor requires an input voltage, Vcc, between 4.5 and 24 V and draws a maximum of 10 mA. The A and B outputs are square waves from 0 V to Vcc approximately 90° out of phase. The frequency of the transitions tells you the speed of the motor, and the order of the transitions tells you the direction.

By counting both the rising and falling edges of both the A and B outputs, it is possible to get 7 counts per revolution of the motor shaft by both Channels.

Encoder comes complete accessories required to mount the encoder on motor i.e. plastic case, washer, magnet, connecting cable and set of screws.

Encoder Pinouts:

  1. Hall Sensor Vcc
  2. Hall Sensor GND
  3. Hall Sensor A Vout
  4. Hall Sensor B Vout
  5. Motor -
  6. Motor +

Package Includes:

1 x Encoder Board. 1 x Plastic Case and Washer. 1 x Magnet. 1 x Connecting cable. 2 x Screws.

Quick specs

Model No. / Name
Magnetic Encoder
Supply Voltage
4.5 ~ 24
Supply Current
14
Output Current (mA)
&lt; 0.1
Leakage Current
10µA
Opt. Relative Humidity(RH)
20% ~ 85% RH
See all specifications