
At a glance
Made by Espressif, this espressif dev. boards and modules is a good fit for makers, students and electronics hobbyists. Main specs: item type ESP32 Based; interface I2S, I2C, SDIO, ADC, UART, GPIO; shipping weight 0.07 kg.
Key Highlights
- Small and easy to carry or mount
- Item Type: ESP32 Based
- Interface: I2S, I2C, SDIO, ADC, UART, GPIO
- Shipping Weight: 0.07 kg
Ideal For
- Arduino, ESP32 and Raspberry Pi projects
- School and college lab work
- Prototypes and test rigs
Buying Tip
Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.
Specifications
| Item Type | ESP32 Based |
|---|---|
| Flash | 8 MB flash |
| PSRAM | 8 MB |
| Interface | I2S, I2C, SDIO, ADC, UART, GPIO |
| Shipping Weight | 0.07 kg |
| Shipping Dimensions | 14 × 11 × 6 cm |
Overview
The Espressif ESP32-LyraT-Mini V1.2 Development board, made by Espressif, is listed in our espressif dev. boards and modules range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.
Specifications explained
- Item Type: ESP32 Based
- Flash: 8 MB flash (space for firmware, files or media)
- PSRAM: 8 MB
- Interface: I2S, I2C, SDIO, ADC, UART, GPIO (confirm your cable or board uses the same connector)
- Shipping Weight: 0.07 kg (important for drones, RC models and anything you carry)
- Shipping Dimensions: 14 × 11 × 6 cm (measure your mounting space before ordering)
Before you order
Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.
Features:
- The audio codec chip, ES8311, is a low power mono audio codec. It consists of 1-channel ADC, 1-channel DAC, low noise pre-amplifier
- Output socket to connect headphones with a 3.5 mm stereo jack. (Please note that the board outputs a mono signal)
- Output socket to connect 4 ohm speaker. The pins have a standard 2.54 mm / 0.1” pitch.
- Functions as the communication interface between a PC and the ESP32.
- Provides the power supply for the board.
- The Standby green LED indicates that power has been applied to the USB Power Port. The Charging red LED indicates that a battery connected to the Battery Socket is being charged
- Power on/off knob: toggling it to the top powers the board on; toggling it to the down powers the board off
- Red LED indicating that Power On Switch is turned on.
Package Includes:
1 x Espressif ESP32-LyraT-Mini Development boardQuick specs
- Item Type
- ESP32 Based
- Flash
- 8 MB flash
- PSRAM
- 8 MB
- Interface
- I2S, I2C, SDIO, ADC, UART, GPIO
- Shipping Weight
- 0.07 kg
- Shipping Dimensions
- 14 × 11 × 6 cm



















