Skip to main content

Worldwide Shipping · Secure Payments

At a glance

This audio amplifier module is a good fit for makers, students and electronics hobbyists. Main specs: output power (w) 50; no. of channels 2; model no. / name TDA7492. Check that your power source supplies 10 to 26 before connecting it.

Key Highlights

  • Output Power (W): 50
  • No. of Channels: 2
  • Model No. / Name: TDA7492

Ideal For

  • Arduino, ESP32 and Raspberry Pi projects
  • School and college lab work
  • Prototypes and test rigs

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

Output Power (W)50
Operating Voltage (VDC)10 to 26
No. of Channels2
Model No. / NameTDA7492
Working ModeClass D (PWM modulation type)
Length (mm)72
Width (mm)58
Weight (g)58
Shipping Weight0.35 kg
Shipping Dimensions7 × 6 × 3 cm

Overview

The TDA7492 50*2 100W HighPower Digital Amplifier Board is listed in our audio amplifier module range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Output Power (W): 50
  • Operating Voltage (VDC): 10 to 26 (match this to your power supply; too high a voltage can damage the part)
  • No. of Channels: 2
  • Model No. / Name: TDA7492
  • Working Mode: Class D (PWM modulation type)
  • Length (mm): 72 (measure your mounting space before ordering)
  • Width (mm): 58 (measure your mounting space before ordering)
  • Weight (g): 58 (important for drones, RC models and anything you carry)

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

This low-cost FX-Audio amplifier module is based on a TDA7492 amplifier chip allowing it to deliver a power of 2x50W under 8Ω, and this has high efficiency due to its Class D architecture. The module can also be used in BTL (bridge) mode for the power of 1x100W under 4Ω. The amplifier chip is combined with a heat sink to ensure proper heat dissipation. On the connector site, there is a PH 2.0mm 3 pins connector at the input and screw terminals at the output for the left and right channels.
Note:
*When the speaker impedance is 4 ohms, the operating voltage must be less than 18V. *When the speaker impedance is 6 ohms, the operating voltage can not exceed 24V. *When the speaker impedance is 8 ohms, the working voltage can not exceed 26V. The power not to reverse the polarity.

Features:

  1. Class D amplifier produces 2 x 50 watt @ 8 ohms
  2. Can be wired R+ to L+ for mono mode
  3. 8" stereo wiring harness included
  4. Short-circuit and over-temperature protection
  5. Supply Voltage 10-26 V DC

Package Includes:

1 x TDA7492 50*2 100W HighPower Digital Amplifier Board

1 x 8" Stereo Wiring Cable

Quick specs

Output Power (W)
50
Operating Voltage (VDC)
10 to 26
No. of Channels
2
Model No. / Name
TDA7492
Working Mode
Class D (PWM modulation type)
Length (mm)
72
See all specifications