Skip to main content

Worldwide Shipping · Secure Payments

At a glance

This rotary encoder is a good fit for makers, students and electronics hobbyists. Main specs: model no. / name Speed Measuring Module; operating voltage (vdc) 3.3 to 5; length (mm) 32. Check that your power source supplies 3.3 to 5 before connecting it.

Key Highlights

  • Model No. / Name: Speed Measuring Module
  • Operating Voltage (VDC): 3.3 to 5
  • Length (mm): 32

Ideal For

  • Everyday use

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

Model No. / NameSpeed Measuring Module
Operating Voltage (VDC)3.3 to 5
Length (mm)32
Width (mm)14
Weight (g)2
Shipping Weight0.005 kg
Shipping Dimensions5 × 4 × 3 cm

Overview

The Groove Coupler Speed Measuring Sensor Module is listed in our rotary encoder range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Model No. / Name: Speed Measuring Module
  • Operating Voltage (VDC): 3.3 to 5 (match this to your power supply; too high a voltage can damage the part)
  • Length (mm): 32 (measure your mounting space before ordering)
  • Width (mm): 14 (measure your mounting space before ordering)
  • Weight (g): 2 (important for drones, RC models and anything you carry)
  • Shipping Weight: 0.005 kg (important for drones, RC models and anything you carry)
  • Shipping Dimensions: 5 × 4 × 3 cm (measure your mounting space before ordering)

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

This is Speed Measuring Sensor Groove Coupler Module For Arduino. The DO output interface can be directly connected to a micro-controller IO port if there is a block detection sensor, such as the speed of the motor encoder can detect.

DO modules can be connected to the relay, limit switch, and other functions, it can also with the active buzzer module, compose alarm. Widely used in motor speed detection, pulse count, the position limit, etc.

Wiring Specification :
  1. VCC: The positive 3.3-5 v power supply.
  2. GND: Connect power negative.
  3. DO: TTL switch signal output.
  4. AO: This is analog output.

Feature :

  1. Using imported groove optical coupling sensor, width 5mm.
  2. It has the output state light, if output high level, the lights are off. if output low level, it on.
  3. If it covered, it will output high level; otherwise, its output low level.
  4. Good signal and waveform, with a strong driving ability for more than 15mA.
  5. Equipped with a fixed bolt hole, easy install.
  6. Use the LM393 wide voltage comparer.
  7. The DO output interface can be directly connected to a micro-controller IO port if there is a block detection sensor, such as the speed of the motor encoder can detect.
  8. DO modules can be connected to the relay, limit switch, and other functions, it can also with the active buzzer module, compose alarm.

Package Includes :

1 x Speed Measuring Sensor Groove Coupler Module For Arduino.

Quick specs

Model No. / Name
Speed Measuring Module
Operating Voltage (VDC)
3.3 to 5
Length (mm)
32
Width (mm)
14
Weight (g)
2
Shipping Weight
0.005 kg
See all specifications