Skip to main content

Worldwide Shipping · Secure Payments

At a glance

Made by Microchip Technology, this drivers and interfaces ic is a good fit for everyday home and hobby use. Main specs: manufacturer Microchip Technology; configuration 16bit; no. of bits 16bit. Check that your power source supplies 1.8 before connecting it.

Key Highlights

  • Manufacturer: Microchip Technology
  • Configuration: 16bit
  • No. of Bits: 16bit

Ideal For

  • Everyday use

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

ManufacturerMicrochip Technology
Configuration16bit
No. of Bits16bit
Operating Frequency (MHz)10MHz
InterfaceSerial, SPI
Min Supply Voltage1.8
Max. Supply Voltage (V)5.5
Case/PackageSOIC
No. of Pins28
No. of I/O pins16
Operating Temperature (°C)-40°C
Operating Temperature Max125°C
Product RangeMCP23017, MCP23S17
Shipping Weight0.001 kg
Shipping Dimensions1 × 1 × 1 cm

Overview

The MCP23S17-E/SO MICROCHIP I/O Expander, 16 bit, Serial, SPI, 1.8 V, 5.5 V, SOIC, 28 Pins, made by Microchip Technology, is listed in our drivers and interfaces ic range and suits everyday home and hobby use. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Manufacturer: Microchip Technology
  • Configuration: 16bit
  • No. of Bits: 16bit
  • Operating Frequency (MHz): 10MHz (make sure the rest of your system works at this frequency)
  • Interface: Serial, SPI (confirm your cable or board uses the same connector)
  • Min Supply Voltage: 1.8 (match this to your power supply; too high a voltage can damage the part)
  • Max. Supply Voltage (V): 5.5 (match this to your power supply; too high a voltage can damage the part)
  • Case/Package: SOIC

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

The MCP23S17-E/SO device provides 16-bit, general-purpose parallel I/O expansion for I2C bus or SPI applications. The device has an I2C interface. The MCP23S17-E/SO consists of multiple 8-bit configuration registers for input, output, and polarity selection. The system master can enable the I/Os as either inputs or outputs by writing the I/O configuration bits (IODIRA/B). The data for each input or output is kept in the corresponding input or output register. The polarity of the Input Port register can be inverted with the Polarity Inversion register. All registers can be read by the system master. The 16-bit I/O port functionally consists of two 8-bit ports (PORTA and PORTB). The MCP23S17-E/SO can be configured to operate in the 8-bit or 16-bit modes via IOCON.BANK.
Applications:

Communications & Networking, Consumer Electronics, Embedded Design & Development, Multimedia.

Note: For more technical details go through Datasheet in the attachment section.

Features:

  1. High-speed I2C interface
  2. Three hardware address pins to allow up to eight devices on the bus
  3. Configurable interrupt output pins
  4. Configurable as active high, active low or open drain
  5. INTA and INTB can be configured to operate independently or together
  6. Configurable interrupt source
  7. Interrupt on change from configured register defaults or pin changes
  8. Polarity Inversion register to configure the polarity of the input port data

Package Includes:

1 x MCP23S17-E/SO MICROCHIP I/O Expander, 16 bit, Serial, SPI, 1.8 V, 5.5 V, SOIC, 28 Pins

Quick specs

Manufacturer
Microchip Technology
Configuration
16bit
No. of Bits
16bit
Operating Frequency (MHz)
10MHz
Interface
Serial, SPI
Min Supply Voltage
1.8
See all specifications