Skip to main content

Worldwide Shipping · Secure Payments

At a glance

Made by Adafruit, this boards compatible with arduino is a good fit for makers, students and electronics hobbyists. Main specs: item type Development Board; board type Feather Type; chipset INA219B chip. Check that your power source supplies 3.3V before connecting it.

Key Highlights

  • Item Type: Development Board
  • Board Type: Feather Type
  • Chipset: INA219B chip

Ideal For

  • Arduino, ESP32 and Raspberry Pi projects
  • School and college lab work
  • Prototypes and test rigs

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

Item TypeDevelopment Board
Board TypeFeather Type
ChipsetINA219B chip
Voltage Regulator3.3V
Shipping Weight0.007 kg
Shipping Dimensions11 × 10 × 1 cm

Overview

The Adafruit INA 210 Feather Wing, made by Adafruit, is listed in our boards compatible with arduino range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Item Type: Development Board
  • Board Type: Feather Type
  • Chipset: INA219B chip (look up this chip to confirm it runs the firmware or libraries you plan to use)
  • Voltage Regulator: 3.3V (match this to your power supply; too high a voltage can damage the part)
  • Shipping Weight: 0.007 kg (important for drones, RC models and anything you carry)
  • Shipping Dimensions: 11 × 10 × 1 cm (measure your mounting space before ordering)

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

The INA219 FeatherWing makes power-monitoring problems a thing of the past. Instead of struggling with two multimeters, you can just use the handy INA219B chip on this breakout to both measure both the high side voltage and DC current draw over I2C with 1% precision. Works with any and all Feathers! Communicates over I2C so its super-simple to use, you can even change the I2C address to have up to 4 of these Wings on one Feather. Many current-measuring devices are only good for low side measuring. That means that unless you want to get a battery involved, you have to stick the measurement resistor between the target ground and true ground. This can cause problems with circuits since electronics tend to not like it when the ground references change and move with varying current draw. This chip is much smarter - it can handle high side current measuring, up to +26VDC, even though it is powered with 3.3V. It will also report back that high side voltage, which is great for tracking battery life or solar panels. A precision amplifier measures the voltage across the 0.1 ohm, 1% sense resistor. Since the amplifier maximum input difference is ±320mV this means it can measure up to ±3.2 Amps. With the internal 12 bit ADC, the resolution at ±3.2A range is 0.8mA. With the internal gain set at the minimum of div-8, the max current is ±400mA and the resolution is 0.1mA. Advanced hackers can remove the 0.1 ohm current sense resistor and replace it with their own to change the range (say a 0.01 ohm to measure up 32 Amps with a resolution of 8mA)

Package Includes:

1 x Adafruit INA 210 Feather Wing

Quick specs

Item Type
Development Board
Board Type
Feather Type
Chipset
INA219B chip
Voltage Regulator
3.3V
Shipping Weight
0.007 kg
Shipping Dimensions
11 × 10 × 1 cm
See all specifications