Skip to main content

Worldwide Shipping · Secure Payments

At a glance

Made by FTDI, this usb interface module is a good fit for makers, students and electronics hobbyists. Main specs: model no. / name Module; data transfer rate 3MBaud; no. of channels 1. Check that your power source supplies 1.8V to 5V before connecting it.

Key Highlights

  • Model No. / Name: Module
  • Data Transfer Rate: 3MBaud
  • No. of Channels: 1

Ideal For

  • Arduino, ESP32 and Raspberry Pi projects
  • School and college lab work
  • Prototypes and test rigs

Buying Tip

Compare the pin layout and operating voltage with your circuit, and order a spare or two: small parts are easy to damage while soldering.

Specifications

Model No. / NameModule
Data Transfer Rate3MBaud
No. of Channels1
USB SpeedFull Speed (12Mbps)
USB ConnectorType B
I/O pin voltage1.8V to 5V
Virtual Com PortYes
Shipping Weight0.015 kg
Shipping Dimensions6 × 4 × 2 cm

Overview

The FTDI-MM232R-USB 2.0 to UART (RS232/RS422/RS485) Bridge Interface Evaluation Board, made by FTDI, is listed in our usb interface module range and suits makers, students and electronics hobbyists. The notes below explain the main specifications and what to check before you order.

Specifications explained

  • Model No. / Name: Module
  • Data Transfer Rate: 3MBaud
  • No. of Channels: 1
  • USB Speed: Full Speed (12Mbps)
  • USB Connector: Type B (confirm your cable or board uses the same connector)
  • I/O pin voltage: 1.8V to 5V (match this to your power supply; too high a voltage can damage the part)
  • Virtual Com Port: Yes (confirm your cable or board uses the same connector)
  • Shipping Weight: 0.015 kg (important for drones, RC models and anything you carry)

Before you order

Compare the specifications with your project or device, and check delivery times and return terms for your country in our help centre. Questions about this item? Email [email protected] with the product code.

The MM232R is a mini-development module for the FT232RQ IC unit. It is a little bigger than a USB connector and provides a USB – Serial UART interface in a extremely small form factor. It is ideal for new development purposes, and also for adding a USB interface to existing product designs. Based on the FT232RQ unit, the MM232R supports RTS/CTS hardware handshaking and is powered from the USB port. Serial data communication is possible at up to 3MBaud at the TTL level. In addition, some of the EEPROM configurable CBUS pins of the FT232R are brought out allowing the MM232R to be used to provide clock signals to external logic. Two 1×4, and one 2×4 board headers are supplied with the MM232R to allow for rapid prototyping and development. Note: For more technical details go through Datasheet in the attachment section 

Features:

  1. Easy to use
  2. Easy to install
  3. Good quality Product

Package Includes:

1 x FTDI-MM232R-USB 2.0 to UART (RS232/RS422/RS485) Bridge Interface Evaluation Board.

Quick specs

Model No. / Name
Module
Data Transfer Rate
3MBaud
No. of Channels
1
USB Speed
Full Speed (12Mbps)
USB Connector
Type B
I/O pin voltage
1.8V to 5V
See all specifications